Loading

Support stand for Manaka Lala figureSupport stand for Manaka Lala figureDiary

randomviewer896randomviewer8964 года назад
I created a support for my Lalachan figure because I didn't want it leaning all on her back leg.

I had the circular base cut out of acryllic and the rod extending up is 3/8ths of an inch in diameter.

I cut/sanded the acryllic rod down until it was the right height, then I rounded the edges on the top before gluing the rod to the round base.

The total height of support I made is 2.82 inches tall.

http://s1.tsuki-board.net/image/600/randomviewer8961451849832.jpeg


http://s1.tsuki-board.net/image/600/randomviewer8961451849830.jpeg
3,546 просмотр. • 0 избран.6 комментариев

Комментарии6

caneton4 года назад#6590439wow, i'd buy one of these from you for my lala. i'm worried about her leaning but she's just too beautiful to resist.

I just sent you a PM.
4 года назад
wow, i'd buy one of these from you for my lala. i'm worried about her leaning but she's just too beautiful to resist.
4 года назад
randomviewer8964 года назад#5822879I don't really have one... I made it without taking any pictures of the process.
Heeeee... Better tag it as diary so.
4 года назад
Thst is a really nice PreCure poster! ^.^/
4 года назад
ney4 года назад#5822832Good job :) but where is the tutorial ?
I don't really have one... I made it without taking any pictures of the process.
4 года назад
Good job :) but where is the tutorial ?
4 года назад
Anime Figure Store

Об этом блоге

Связанные клубы1